Veteran Garage Door Repair | Keller TX | 817-769-8488

Garage Door Opener Repair

You might locate that your garage door opener has been providing you problems, so you require to fix it. You can fix it by replacing a circuit board, a photo-eye sensing unit, the primary drive equipment, or the set-limit buttons. You can likewise examine if the safety sensing units are working properly.

Replacing a circuit card

Changing a motherboard for your garage door opener needs a couple of steps as well as devices. First, you require to turn off the circuit breaker as well as disconnect any kind of wires. Next off, open the circuit card cover. This will help you to detect the trouble and also establish if you require a brand-new board. Next, remove the old board as well as its cable connectors.

You can after that proceed to change the motherboard. The substitute procedure is very easy and also takes around 10 mins. A brand-new circuit card will certainly cost concerning $80. To shield your new circuit card from power surges, you can purchase a surge guard.

Replacing a photo-eye sensing unit

Replacing a photo-eye sensor can be a fairly easy job. Initially, get rid of the sensing unit from the door as well as make sure it is located appropriately. If the sensing unit is angled at all, it might not be receiving the right signal, which could be triggering the strobe lights. If you see that the photo-eyes run out positioning, you may require to have a specialist come and fix the issue.

The photo-eye sensing unit contains 2 items that mount on the outside of the door tracks and toward the floor. The image eyes will certainly have a tiny LED light and should be solid in color. If the light is blinking, its likely the photo-eye is malfunctioning as well as will certainly need to be replaced.

Changing a primary drive gear

To change a garage door opener primary drive equipment, begin by getting rid of the cap from the chain sheave. Next, remove both screws holding the drive equipment to the gear setting up. Now, you can unfasten the three tension pins. Press them from both sides and after that eliminate them. Then, disconnect the 3 wires from the garage door opener electric motor. These cables must be white, red, and blue.

Once you have actually eliminated the old equipment, install a brand-new one. Make certain to oil it well. Place the new equipment into the shaft, seeing to it to align the installing openings. Ensure the gear and sprocket assembly are located appropriately to guarantee smooth operation. Next, make use of a hammer and a nail to drive a pin right into the brand-new gear.

Adjusting the set-limit buttons

The very first point you need to do if your garage door is not functioning appropriately is to inspect the set-limit buttons. You might require to change them to make sure that the door shuts earlier or quits prior to it gets to the floor. You can check this by taking a look at your garage doors handbook or online.

To readjust the set-limit switches, youll need a screwdriver or socket. Change the handle clockwise or counterclockwise till the door goes up as well as quits, or decreases its distance. To check for correct travel range, determine the void from all-time low of the garage door to the ground.

Veteran Garage Door Repair – Keller

204 S Main St Ste 105, Keller, TX 76248, United States

817-769-8488

https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/


Garage Door Repair


Garage Door Installation


Garage Door Company


Garage Door Service


Garage Door Opener Repair

Veteran Garage Door Repair

204 S Main St Ste 105
Keller,TX
76248
817-769-8488

Leave a Reply

Your email address will not be published. Required fields are marked *


Back To Top